UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
A
Reaction score
24

Latest activity Postings About

    • A
      andrew_2 replied to the thread Kitchen door repair.
      I had to do exactly this a couple of months back. I made this little block as a drill guide for a 20mm forstner bit. The thin bits are...
      • hingething.jpg
    • A
      andrew_2 reacted to pe2dave's post in the thread Hand router plane... with Like Like.
      Youtube review, Bisch basch bosh if you know him. Very tempted...
    • A
      andrew_2 reacted to Fergie 307's post in the thread Barrel top dresser delaminated with Like Like.
      Only time I have done this on a curved surface was on a clock similar to the picture, where the top and one side of the curved hood had...
    • A
      andrew_2 replied to the thread Vice lining?.
      I got a very stout and nice chunk of leather from my local trad shoemender. It cost me a tenner.
    • A
      andrew_2 reacted to Phil Pascoe's post in the thread Vice lining? with Like Like.
      As said above - if you need huge pressure in a vice there's usually a better way of doing the job. My vice gets used for anything and...
    • A
      andrew_2 reacted to Orraloon's post in the thread Vice lining? with Like Like.
      Bare wood is as good as any and pine is more grippy than really hard woods. Leather is good if you are holding delicate bits of work. I...
    • A
      andrew_2 reacted to SkinnyB's post in the thread Slipping F-clamps with Like Like.
      As promised some photos. The grub screw is a little long but I tend to use what I have on hand. You don't need to adjust it every time...
    • A
      andrew_2 replied to the thread Slipping F-clamps.
      Very good point about the cast iron wearing out rather than the bar.
    • A
      andrew_2 replied to the thread Slipping F-clamps.
      That sounds like a neat solution. I'll give it a go when the next one starts to fail. Thanks!
    • A
      andrew_2 reacted to SkinnyB's post in the thread Slipping F-clamps with Like Like.
      Best way I found to fix these is to tap for a grub screw on the back of the part that slides up and down. Try to get the grub screw near...
    • A
      This is for all the poor impoverished amateurs like me out there. I just saw a Wallybois short on Youtube about how to cure slipping...
      • fclamp1.jpg
      • fclamp2.jpg
  • Loading…
  • Loading…
Back
Top