Hi all
I haven't been here for a while so sorry if this is a well flogged subject.
I have a BAS 315 bandsaw. I think it's pretty rough to be honest but it works.
I would like to rip some timber and oak is included if possible width up to 125mm but around 100mm would be the norm. .
The blade is 88" in length but I am not sure how wide the blade can go up to. The rubber belt that the blade runs on is 20mm wide.
I believe the less teeth per inch is better so a 3tpi blade sound right.
Also would like to upgrade the top and bottom guide bearing units not just the bearings.
Has anyone any ideas or suggestions. :?:
A source of good long lasting blades would be very helpful
I haven't been here for a while so sorry if this is a well flogged subject.
I have a BAS 315 bandsaw. I think it's pretty rough to be honest but it works.
I would like to rip some timber and oak is included if possible width up to 125mm but around 100mm would be the norm. .
The blade is 88" in length but I am not sure how wide the blade can go up to. The rubber belt that the blade runs on is 20mm wide.
I believe the less teeth per inch is better so a 3tpi blade sound right.
Also would like to upgrade the top and bottom guide bearing units not just the bearings.
Has anyone any ideas or suggestions. :?:
A source of good long lasting blades would be very helpful