thomaskennedy
Established Member
Hi all!
Was playing about with SketchUp and came up with this:
As you can (hopefully) see there is a lip at the back to support a toggle clamp such as this:
which will hold the workpiece down, as i find it hard when sometimes handling big sheets on my 10" TS
!
Just a little tip, yes ME, TIP
:shock: :lol: ![Stick out tongue :p :p](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Ta
Tom
ps.'tis not made yet, hence the plan :roll:
*Edit*-Incase you didn't realise it is viewed from the rear right i.e. you will push towards the top right of the picture, (now wasn't THAT clear) :roll:
Was playing about with SketchUp and came up with this:
![Sled2.JPG](https://proxy.imagearchive.com/133/133bc41ad340395200f544064f2e1739.jpg)
As you can (hopefully) see there is a lip at the back to support a toggle clamp such as this:
![acl1.jpg](https://proxy.imagearchive.com/84a/84a7a3c83b81f5a2d4d51bc87116ecef.jpg)
which will hold the workpiece down, as i find it hard when sometimes handling big sheets on my 10" TS
Just a little tip, yes ME, TIP
Ta
Tom
ps.'tis not made yet, hence the plan :roll:
*Edit*-Incase you didn't realise it is viewed from the rear right i.e. you will push towards the top right of the picture, (now wasn't THAT clear) :roll: