EdSutton":1nn5yxpu said:
bugbear":2qdzuuls said:mickthetree":2qdzuuls said:ha thanks all for your suggestions. I think a half descent combination square for general use
This looks like what you want:
http://www.axminster.co.uk/product-Axmi ... -23288.htm
I suspect it's by PEC
Here's a thread:
http://www.forums.woodnet.net/ubbthread ... t=all&vc=1
Here's their site:
http://www.productsengineering.com/tool ... index.html
BugBear
hpl":2e8ty6ca said:I bought one of those, the write up sounds good, but it is a long way out, about 0.5mm over the length of the 300mm rule on the standard 90/45deg stock. With a little bit of fettling I'm sure it could be made right though.
Johnny B
EdSutton":han0os55 said:
hpl":310y1tp0 said:That's interesting BugBear, my squares are all reasonably accurate then. I never realised that a square could be that far out and still be considered square. To me that seems quite a bit out when I am using it. I'll have to check a bit harder on the spec next time I buy one.
Johnny B
Enter your email address to join: