Peter G Denmark
Established Member
So - a fellow from Lumberjocks.com asked me how i did the dust collection on my Wadkin AGS. So i made a short video for him. Since it took me a while to figure it out, i thought i might share it here as well, since others might be in the same situation.
Misterfish was kind enough to help me out by sending me pictures of his original Wadkin setup, so i took it from there, and made this:
http://www.youtube.com/watch?v=_wQ3Llrn ... ure=relmfu
Since i made the video, i actually bought one of those magnetic signs you see on student driver cars, that i cut in half, and put a notch in, to fit over the hole where the tilt handle moves. It actually says "student driver" (in Swedish though), which i think is kind of cool.
I also ut some foam rubber in the slot under the table
So - now most of the air is sucked down throught the throat, so boring a couple of ekstra holes in your (home made zero clearance) insert will help getting more airflow where you want it.
Misterfish was kind enough to help me out by sending me pictures of his original Wadkin setup, so i took it from there, and made this:
http://www.youtube.com/watch?v=_wQ3Llrn ... ure=relmfu
Since i made the video, i actually bought one of those magnetic signs you see on student driver cars, that i cut in half, and put a notch in, to fit over the hole where the tilt handle moves. It actually says "student driver" (in Swedish though), which i think is kind of cool.
I also ut some foam rubber in the slot under the table
So - now most of the air is sucked down throught the throat, so boring a couple of ekstra holes in your (home made zero clearance) insert will help getting more airflow where you want it.