Current storage is outside, under cover (nearly) and not heated. Planks are about 18mm thick. It's an old gym floor (see my previous posts) so no planing of the surface planned - we want to retain the markings and will accept the worn look. Shortening the long ones is starting to sound very...
Cheers - wood is about to be denailed and stored in the building where it will be laid eventually. Has been under cover outside the building for a couple months. I've got at least twice what I need for my main floor. I've got other rooms we might put it into later on too. Was planning to joint...
I'm ready now to get my table saw to start prepping my salvaged mahogany planks. I need to trim the current t&g and get the planks to a uniform thickness, and cut a new groove in each side of them.
So - how good a table saw do I need to ensure my planks (1-4m in length) are going to be...
Apparently the bed is 7" wide. I take it thats my width limit on pieces of wood? I'm thinking of doing a 20ft double ender boat and can't decide if I need a 10x6 or if this would be adequate?
Chaps - we're between Horsham and Haywards Heath. Pm me for postcode. Wood is on my neighbours farm so I have to respect his privacy.
There is still 1-2 van loads left. Will post a picture later!
(I know this should be in the marketplace but I don't have enough posts...!)
We rescued a wooden floor from a local college and we've taken enough planks for our project. I now need to rapidly clear the remaining wood.
It's mainly splintered or short sections. If I can't clear it I'll have to...