Hello
I need your help, I am renewing my Garden bench, I have two iron ends and removed the decayed slats, they are 2 1/4 x 3/4 inches, 4 feet long what kind of timber would be suitable? and would a firm supply them to size?
Please advise me.
guyos
Shed9
Many Many thanks.
It is the right blade and I have ordered from Solent.
I had searched everywhere through google and could not find it. Now I don't need to dump my jointer.
Thanks again.
Guyos
OH Dear
Finally tracked down my blade. 156x16.5x3mm
Problem is its from Alibaba and I would need to order 10 pairs minimum.
Now the search is on for a retailer who buys from Alibaba and resells.
Any leads Please.
Guyos
Thanks guys I seem to have got it set up, a straight edge placed on top of the outfeed table and blade moves a 1/4 " when I turn the cylinder.
Nice video Steve.
My only problem now is to find blades to fit my B&Q machine. that seems impossible.
Hello
can someone please tell me :
When setting the jointer knives, should I have the machine depth of cut set to minimum or maximum?
I have had it set to zero is that right?
guyos
I have a Jointer bought from B&Q Performance Power Bench Planer/Jointer NLH1280J 1280W
does anyone know where I can buy replacement blades? I have searched everywhere, the nearest I got was a sip blade that looks identical thickness width slots except for the length which is 3mm longer...
Thanks Sunnybob
I have found my mistake.
The first knife came out with the fence in place, but I have since removed the fence and found a screw that I was missing.
All went well from then, all set up now.
Thanks again.
guyos
Hi
i have a B&Q jointer performance power 1280 no hand book.
I am trying to set the blades, but I did one blade turned the 4 screws and everything went well blade came out and I was able to reset it.
Now when I try to do the other blade, same procedure undo the screws as normal, nothing...
Thanks Tudor, yes when I bought the rod at B&Q I thought it was a 3/8 rod. It was the nuts that I had to use that made me twig they were M10 nuts.
My kerf is exactly 1/8 measured by calliper and micrometer.
My apology for a saw would not lend itself to any arbor adjustments.
It did take a...
Hello folks
I have built a box joint jig, but I am unable to get a joint that fits. I have been advised the number of cuts and turns to make but joints are too loose. I suspect that because my saw kerf is 1/8" and the rod an M10 (don't know the TPI) that could be the cause of the problem.
If I...