Recent content by CS Bespoke Furniture

Very true. Know any reputable companies that do custom irons then?

Was a little worried about the heat to be honest. Too hot and it could catch fire and too cold it won't burn. Saying that I've never used one so I don't know.

Hi, I want to get a laser engraver to print my logo onto wood. Most of the time it will be Oak or Ash. Does anyone have any experience or know what they are looking at with these. It seems to be a minefield with all the different models and prices. Mixed reviews and I don't know what one to...

They do! Will get me out of a tight stop for a while. Shame they don't do the 6mm ones. Thanks!

These ok to use when pushing wood in from the side though?

just phoned them. they can't help unfortunately

I have got a german router table called the Feider F15TPVS. Its actually a pretty good table but it only comes with metric collects (6, 10 and 12mm). Router bits seem to be very rare in these sizes and now i need more i can't seem to find any. So 2 questions - 1. Is there a collect that will...

Hey everyone, need some advice on Forstner bits. I currently have a 40mm bosch knife edge bit and it burns like crazy. I heard recently the knife edge bits are much better when below 25mm. So I've been looking around and have come across a few different designs. A wavy edge bit, a saw tooth bit...

If its smaller sizes then 1000 x 200 x 25 would be perfect. If bigger sizes then anywhere between 2.7-3m x 200 x 25. thanks for the numbers though, ill give them a try tomorrow

Don't suppose you can get any American walnut can you? Getting restricted on sizes at the moment. People only seem to do 2.4m and i need at least 2.7

Must have only seen quarter cut before. Crown cut is much nicer I think! Hope I can get more of it locally. Thank you everyone

Need an opinion on this wood please, I normally only work with lighter wood so still need experience with this. I asked for sapele but this doesn't look quite how I expected it too. I have normally seen sapele with big waves in the grain. I do love this wood though and just want to know what it...

Hi All, Does anyone know of a machine service place in the cambridgeshire area. Have a startrite sd300 that I have purchased second hand and want to give it a thorough once over. Make sure everything is working as it should. thank you Chris

Oh don't worry I wouldn't touch electrics with a barge pole! Get a professional to do it. Not worth the hassle and if it's goes even slightly wrong it's so dangerous. Plus it would need to be insured. That's not going to be for a while though

Yeah 16amp not volt lol. That's good advice though. I do want to expand the workshop at some point and that's when I will do a lot of work on the electrics.