Blacon

Thanks, i did figure where they went i had to order some bolts, losing stuff in my disorganised garage, doh

Anybody know how this goes together?

Video telling me its not together correctly

Thanks for your reply, i going to keep it i think. But i would like a copy of the manual, when i got it all the parts where not...

I dont have any splashback so if i fit some this cover up the gap left from shortening the top , i hope? I iam raising the top an inch .

I must have got my video's mixed up . I am going to use a circular saw making sure the blade, as you say "cuts up"

Hi, we got a wood lathe small to medium size in need of tlc. Its just basic sits on aliminium bed motor and belt drive. Can get pictures...

I got a scroll saw project on the go. Its a 18" circa 1993. I got this in rusty condition, so took it to pieces awhile ago now i got a...

Found a YouTube blog which answered my questions, thanks

Thanks for the videoo link, but what I'm stressed about is tHe cutting and not chipping the edge

Not quitr ready for doing the job soi time to get the process in m y head, phew note : my worktop is square edge with metal side

Hi roy The burn ismy doing, i had the voltage at the motor for only 2 sec. Then the relay tripped , so i used oneside off the rely...

I am not happy with my current worktop with those joining strips fitted leaving bump on the worktop. So i intend to use same worktop ...

Thanks Spectric, i spent 40mins yesterday one finger typing only for it to disappear. So will try again. The motor is the target of...