spindle moulder training
- Thread starter bvmsheds
- Start date
Help Support UKworkshop.co.uk:
rhrwilliams
Established Member
Hi, no replies so maybe I can help....
I don't know of anywhere for training. There is a video on youtube which I think is good which explains the basics - If you haven't got a power feed just make sure you use sacrificial fences etc.
https://www.youtube.com/watch?v=B4Kqxl1P3EY
I got a spindle moulder a good few years ago now and at first it was daunting but I had lots of help from people on here and the other forum.
As long as you check the machine, make sure you are using a modern safe block (euro block or whitehall block with locator pins) , make sure the block is fixed down properly , make sure you have and sacrificial fences etc and don't stick your hands in it you should be fine.
I don't know of anywhere for training. There is a video on youtube which I think is good which explains the basics - If you haven't got a power feed just make sure you use sacrificial fences etc.
https://www.youtube.com/watch?v=B4Kqxl1P3EY
I got a spindle moulder a good few years ago now and at first it was daunting but I had lots of help from people on here and the other forum.
As long as you check the machine, make sure you are using a modern safe block (euro block or whitehall block with locator pins) , make sure the block is fixed down properly , make sure you have and sacrificial fences etc and don't stick your hands in it you should be fine.
it is a trip over to Gods Country, but you could try http://www.christribefurniturecourses.c ... k-courses/
I am not 100% sure whether Chris does spindle training, but worth asking.
I am not 100% sure whether Chris does spindle training, but worth asking.
rhrwilliams
Established Member
Ive just seen advertised Spindle Moulder Training day at Axminster tools - Do you have Axminster in Lancashire ?
