sams93

You will find a great deal of advice on this forum and if you post about your problems as and when they arise I have no doubt there is...

I completely rebuilt a 636 planer/thicknesser about 18 months ago. I bought it in a bit of a state from an old barn clearance, stripped...

He wanted a slice through a tree trunk, with bark intact. Doesn't matter hugely about the thickness, probably ideally 30mm or so. It...

I'm saying that I used a real oak kitchen worktop (not veneer) in the end. Worktops are made of smaller staves so there are joints and...

That was on ebay https://www.ebay.co.uk/itm/285448187697 In the end I made the shelves out of old kitchen worktop, was cheaper and...

My uncle asked me today if I could make/get a 'cookie' slice he wants for a cake stand. It needs to be about 50cm diameter which is much...

I use 'Timbashield' from A-Chem which is available in a few colours but I mainly use the clear for outdoor wood and the red cedar one...

This is exactly what Triton did with their TRA001 and TRA002 routers. I have one which I mostly use in a table top (pictured below) but...

I’ll take a stab at left to right Sapele, Iroko, Oak, Red Grandis

High shelves and/or cabinets are not going to affect your useable space, I would be keen to do that. As long as you mount them to the...

Of course, you can add all of this to your hose, however, you have to bear in mind that with every extra cm of hose lengthyou reduce the...

more progress on the FM, it’s really starting to look like a planer again and my big pile of old cast iron is getting smaller and...

It would be good like you say to see some videos of it in action cutting some larger veneer slices.

I have made a veneer cutting appliance for my bandsaw. It’s totally over built, far more over engineered than anything I’ve seen on the...

It would be a shiny penny I should think. It is so well made you have to see it in person to really appreciate it. When I brought it I...