Topcat
New member
I have a small workshop, 6x4M, and use one tool at a time, this will be hand tools, table, band and mitre saw too.
i was looking at the scheppach HA 1000 which was mentioned in a magazine, however this cannot be found to buy anywhere! It is claimed as 0.3 micron filter and about 53L/s or 185m/hr. alternatives are much the same from Record, SIP, Draper and Woodstar but only mention 0.5 micron.
Will one of these be enough for the workshop or should i really be buying a twin motor unit such as Camvac or numatic? I will want a LVHP type.
This is my first extractor so I have no experience and look forward to advice.
Tc
i was looking at the scheppach HA 1000 which was mentioned in a magazine, however this cannot be found to buy anywhere! It is claimed as 0.3 micron filter and about 53L/s or 185m/hr. alternatives are much the same from Record, SIP, Draper and Woodstar but only mention 0.5 micron.
Will one of these be enough for the workshop or should i really be buying a twin motor unit such as Camvac or numatic? I will want a LVHP type.
This is my first extractor so I have no experience and look forward to advice.
Tc
