Wadkin Planer Thicknesser (12”)

[Samk]

I’ve had this machine for a while but it’s never been calibrated quite right. After a few months of YouTube video and trial and error I’ve got the planer working well but the thicknesser table is slightly out to the cutter block. The manual sugests altering the ‘fine thread adjusters on the underside of the table’. I can’t work out which these are so any help is greatly received.

Thanks,

Sam

 

[sawtooth-9]

I think a little more detail on the machine, or some pics - might help people to offer useful advice.
Sounds like a simple adjustment - but the more info you supply, the more help you will get.

 

[Fitzroy]

Alternatively you can pass a full width sacrificial board through the Thicknesser and then us this on top of the Thicknesser table which will ensure square to the knives.