Triton Router and Triton table

[DiscoStu]

I've bought a TRA001 router and table. All good and all seems to be excellent, except....

The insert in the table does not come predrilled for the lift on the TRA001.

Does anyone have a template or some measurements so that I can work out where to drill the hole. I really done want to be out by 20mm

 

[bernienufc]

Use the plastic sheet template with all the rings on, mark the hole from the router base plate and transfer to the table, that's what i did and its fine.
TBH i actually prefer to adjust from under the table using the fine control rather than put the rod down through the table but then my table is open

 

[DiscoStu]

Not sure I know what the plastic sheet template is. Does it have the hole marked?

 

[bernienufc]

pm sent

 

[Benchwayze]

Stu...

Take the thin plastic plate off the bottom of the sole. Use that as a template.

 

[DiscoStu]

Just to update, I realised that the router base had a small notch cut out of it for the raising shaft to pass by, so I used this notch as my guide. All working well.