todays lesson learned...

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
i was trying to drill into the side of a cylinder. i wrapped it tightly in gaffer tape and tried both spur bits and normal twist drill bits but both had break out and break in :shock: and made a right mess of my nicely finished cylinder. :evil:
so MK2 was drilled while it was square stock and then turned to a cylinder, lovely neat sharp edged holes :D
lesson learned :mrgreen:
 
Back
Top