thomaskennedy
Established Member
Hi all!
Was playing about with SketchUp and came up with this:
As you can (hopefully) see there is a lip at the back to support a toggle clamp such as this:
which will hold the workpiece down, as i find it hard when sometimes handling big sheets on my 10" TS !
Just a little tip, yes ME, TIP :shock: :lol:
Ta
Tom
ps.'tis not made yet, hence the plan :roll:
*Edit*-Incase you didn't realise it is viewed from the rear right i.e. you will push towards the top right of the picture, (now wasn't THAT clear) :roll:
Was playing about with SketchUp and came up with this:
As you can (hopefully) see there is a lip at the back to support a toggle clamp such as this:
which will hold the workpiece down, as i find it hard when sometimes handling big sheets on my 10" TS !
Just a little tip, yes ME, TIP :shock: :lol:
Ta
Tom
ps.'tis not made yet, hence the plan :roll:
*Edit*-Incase you didn't realise it is viewed from the rear right i.e. you will push towards the top right of the picture, (now wasn't THAT clear) :roll: