PJM
Member
HI Guys.
I bought a Titan (Screwfix) TTB763TAS Table Saw and have been very pleased with it with one exception. The fence does not go the full depth of the table and is only fixed at the front and ends about 3 quarters before the opposite end. I am therefore concerned about the accuracy as when pushing the workpiece through you might flex the unsupported end and cause some inaccuracy. Also if you have a long workpiece I feel you would need an overhang past the back end of the table to be sure of the accuracy.
Has anyone had the same problem with the same table saw ? and what did you buy or fix, make etc to solve this problem ?
Thanks
Peter
I bought a Titan (Screwfix) TTB763TAS Table Saw and have been very pleased with it with one exception. The fence does not go the full depth of the table and is only fixed at the front and ends about 3 quarters before the opposite end. I am therefore concerned about the accuracy as when pushing the workpiece through you might flex the unsupported end and cause some inaccuracy. Also if you have a long workpiece I feel you would need an overhang past the back end of the table to be sure of the accuracy.
Has anyone had the same problem with the same table saw ? and what did you buy or fix, make etc to solve this problem ?
Thanks
Peter