Table saw cutting up rough. - Axminster AT254SB

[Gary_S]

I noticed that the sawn edge was rough when cutting some oak draw sides. I decided not to be lazy and swapped out the Axcaliber cross cut blade for the Axcaliber rip blade to see if it changed anything. Having realigned my Axminster AT10 Table saw blades and fence. I still have a rough finish. It used to feel like it had been planed. I am now out of ideas. The blades were sharp and clean btw.

 

[Myfordman]

Can't find the AT10 saw on axminster to see what sort of quality it is.
maybe bearings or blade wobble is to blame?

 

[Gary_S]

Can't find the AT10 saw on axminster to see what sort of quality it is.
maybe bearings or blade wobble is to blame?

My mistake, it is the AT254SB. The blade does not appear to wobble.

 

[DBC]

If your saw is running true and your blades are good it might just be the angle of attack on the timber grain. Not many table saw cuts are planer quality after all.