Table saw cutting up rough. - Axminster AT254SB

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

Gary_S

Established Member
Joined
25 Jun 2015
Messages
102
Reaction score
29
Location
Marlborough
I noticed that the sawn edge was rough when cutting some oak draw sides. I decided not to be lazy and swapped out the Axcaliber cross cut blade for the Axcaliber rip blade to see if it changed anything. Having realigned my Axminster AT10 Table saw blades and fence. I still have a rough finish. It used to feel like it had been planed. I am now out of ideas. The blades were sharp and clean btw.
 

DBC

Established Member
Joined
6 Mar 2015
Messages
183
Reaction score
279
Location
Essex
If your saw is running true and your blades are good it might just be the angle of attack on the timber grain. Not many table saw cuts are planer quality after all.
 
Top