billw
The Tattooed One
I have some samples of veneer (A5 size) and I've just ordered some relatively small leaves for a project that's on my list as well as one for future use because I liked it.
However in the meantime I'm going to need to store anything I accumulate. Will just putting them flat between two 18mm pieces of MDF do the job, perhaps separated by sheets of paper? Apparently brown wrapping paper (kraft?) is suitable if unwaxed?
Secondly for usage - without investing in a press or vacuum equipment, what's the sort of size I could expect to produce using clamps and plywood (or anything else that might be suitable)? I'm mainly thinking box lids etc, so up to a sheet of A4 in size in one go?
However in the meantime I'm going to need to store anything I accumulate. Will just putting them flat between two 18mm pieces of MDF do the job, perhaps separated by sheets of paper? Apparently brown wrapping paper (kraft?) is suitable if unwaxed?
Secondly for usage - without investing in a press or vacuum equipment, what's the sort of size I could expect to produce using clamps and plywood (or anything else that might be suitable)? I'm mainly thinking box lids etc, so up to a sheet of A4 in size in one go?