Stl file editing.

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Sheptonphil

Scrumpy junkie
Joined
29 Dec 2012
Messages
1,280
Reaction score
448
Location
Somerset
Hello all, I have an stl file and it 3D prints flawlessly, however, the six pocket holes around the lid need to be 10mm outside diameter, not 9.1mm as per the original stl file. Internal diameter of pocket is fine. I’ve loaded it into Blender, change to edit mode, turn on wireframe view, but it doesnt seem to offer any way of resizing just the six pockets. is there anyone who can point me inthe direction of resizing just the pockets, not scaling the whole lid as it wont then fit the base properly.

thanks in advance for any help
 
Back
Top