September Challenge ( A Vase ) discussion thread

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.
I was done.

Just measured it again and I'm 8 mm short of depth, total hieght 160mm , depth 120mm cant alter it so i think another go is on the cards.
 
j1mbr0wn":38t5xs4k said:
I was done.

Just measured it again and I'm 8 mm short of depth, total hieght 160mm , depth 120mm cant alter it so i think another go is on the cards.

Note to self:

Keep ruler closer to lathe
 
Hudson Carpentry":1y2gnus3 said:
Melinda_dd":1y2gnus3 said:
well i'm happy to report my new lathe has been ordered :D =D>

not so happy to say it won't be in stock until the end of october :cry:
so I'm out this month and probably next too.... Bang goes my 12 points :cry: :cry:

Is there not a member close by that would allow you use of a lathe?

She's more than welcome to use mine on the condition she makes my entry too. ;)
 
Is there not a member close by that would allow you use of a lathe?[/quote]

She's more than welcome to use mine on the condition she makes my entry too. ;)[/quote]

Have you seen my past entries!!! :oops:
 
okay! okay! calm down! calm down! (please pronounce with deep scouse accent) :D
i thought i might be in with a (very :oops: ) small outside chance this month but it seems the vase challenge has woken everybody up :shock: and we're only two thirds through the month :!:
so would everybody please stop adding entries and give me half a chance at the top five :wink: :mrgreen:
 
Status
Not open for further replies.
Back
Top