After routering mdf I always get a "furry" finish, usually I apply some primer to stiffen the "fur" then sand it smooth(ish). is there an easier or quicker way to get rid of it?.
All ideas welcome,
Thanks,
Pip
All ideas welcome,
Thanks,
Pip
Are you talking about doing a climb cut here N_N? If so <granny/eggs> be aware that the router wants to pull you in the direction of the cut, so hang on!Newbie_Neil":2g5ned18 said:When you have made your final pass, don't change anything and just do the cut in reverse.
Aragorn":3gv8lc7h said:Are you talking about doing a climb cut here N_N? If so <granny/eggs> be aware that the router wants to pull you in the direction of the cut, so hang on!
I'll try not to use mdf in future, I prefer looking at a nice piece of grain anyway.
don't worry, I'll cover it up if any ladies come.Midnight":p7q4swct said:I'll try not to use mdf in future, I prefer looking at a nice piece of grain anyway.
the lad's showin potential.... never a bad thing.
Enter your email address to join: