Routing - How much in one pass?

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jokerman

Established Member
Joined
23 Mar 2005
Messages
70
Reaction score
0
Location
Mid Derbyshire
Am I not right in believing that when cutting a rebate in the edge of a panel against a fence less than half the diameter of the cutter, irrespective of the hight of the cutter set, should be presented tp the wood at any one time to prevent tearing the timber. Of course I'm not using a bearing guider cutter just to save asking!
Moving house tomorrow think I'm going slowly mad.
hh
 
Hope the house move goes well
icon_lucky.gif
.

Gill
 
Uggh, good luck with the move did it last year and its horrendous isnt it.

When cutting rebates my self i usually do it in 4 passes, 3 to cut the actual rebate and a final upcut pass to remove any furries or burning left behind.

Signal

PS, Gill is a chapette ;)
 
Back
Top