Woodythepecker
Established Member
- Joined
- 30 Jul 2004
- Messages
- 686
- Reaction score
- 0
My friends granddaughter wants a kitchen in her tree house just like the one i built for her mum. Alright it is only one cabinet with a sink in, but she seems happy enough.
As i wanted to use a smaller then normal cabinet door i couldn't use my spindle moulder, and so i set up the router table. The only trouble is everytime i try to run the raised panel the bit cuts a small piece and then drops below the table.
I have checked the collet which is fine and it is not allowing the bit to recede back into the router. I have also checked the plunge lever which appears ok.
Any ideas would be great?
Regards
Woody
As i wanted to use a smaller then normal cabinet door i couldn't use my spindle moulder, and so i set up the router table. The only trouble is everytime i try to run the raised panel the bit cuts a small piece and then drops below the table.
I have checked the collet which is fine and it is not allowing the bit to recede back into the router. I have also checked the plunge lever which appears ok.
Any ideas would be great?
Regards
Woody