Reply to thread

Shop deals on ebay

shop deals on amazon

wood workers workshop

laguna tools

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

Message: <blockquote data-quote="J-G" data-source="post: 1576643" data-attributes="member: 18744"><p>They are good at carrying 'Odd ball' cutters but I doubt even they'll have such a beast.</p><p></p><p>If you decide to make one from a 12" length of 1" Ø Steel  -  or  300mm of 26mm Ø  -  then you would need to be able to have 200mm+ travel on your top-slide set at 1.718°  but also 75mm travel in the oposite direction set at 1.432096° (this later to cut an MT2 shank).</p><p></p><p>If you <strong><em>can</em></strong> manage 200mm travel, then I would suggest that you buy a Morse Taper #2 'Blank' which you could find a way to fix to a 200+ mm long bar on which you had cut the 1.718° taper.</p><p></p><p>The chance that you would cut an MT2 taper that would really fit is slim. </p><p></p><p>Should you decide to take the 'stepped' route then you need to increase the diameter by 1mm every 16.66667mm of length.</p></blockquote><p></p>

Verification