Raising Panels On The Spindle

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

pollys13

Established Member
Joined
19 Apr 2009
Messages
1,210
Reaction score
3
Location
Swindon
I won a 2nd hand good condition Whitehill Axminster 140mm x 30mm bore panel raising block including the cutters and limiters, less than 1/2 price £98.

Also won a Tormek SVP-80 Profile knife jig £50 unused again less than 1/2 price. I can use this on my carving wetstone grinder, Tormek say I can resharpen spindle knives up to 6 times, quite neat I thought.

Watched a OMAS wobble saw, Sargent were having a special promotion I found the wobble saw would cost about £6 to resharpen, then have to factor in post to and back. So I bought the brand new one, Ebays went for about £10 less than the new one. Also when I start my business I can claim the vat back. So worked out about £105, again quite neat.

As I support EasyFundRaising, the Hillside Animal Sanctuary got a donation from Each Ebay purchase.

Anyway, bla.
When I raise the door panels on the spindle, the flat on the panel will be 10mm thick, how many mm all round do, I oversize the housing to allow for expansion and contraction?
Cheers.
 
Back
Top