devonwoody
Established Member
I have today just completed a new router stand for my Triton workcentre outfit.
The reason for the additional stand is to avoid having to strip off the table saw set up and fit the trition router platform.
I have not had to use any fasteners to keep the router table in place it fits nice and snugly round a table surround.
I might have to weigh the setup down to the floor. I have got a couple of old vices that might do the trick. ( Not the perverted kind!!)
Pictures are available at the ubeat site.
http://www.woodworkforums.ubeaut.com.au ... hp?t=11092
The reason for the additional stand is to avoid having to strip off the table saw set up and fit the trition router platform.
I have not had to use any fasteners to keep the router table in place it fits nice and snugly round a table surround.
I might have to weigh the setup down to the floor. I have got a couple of old vices that might do the trick. ( Not the perverted kind!!)
Pictures are available at the ubeat site.
http://www.woodworkforums.ubeaut.com.au ... hp?t=11092