Billy_wizz
Established Member
Hi does anyone know if the k series had a standard bore for the chisel and bit mounting aperture?
I've measured and am getting 16mm for the bit and just under 30mm for the chisel!
Which I'm assuming by the age the machine would be imperial which gives me 1 5/32 for the chisel
And 5/8 for the bit does this sound right? Also any leads on reducing collets?
Thanks
I've measured and am getting 16mm for the bit and just under 30mm for the chisel!
Which I'm assuming by the age the machine would be imperial which gives me 1 5/32 for the chisel
And 5/8 for the bit does this sound right? Also any leads on reducing collets?
Thanks