A
Anonymous
Guest
I followed the jig competition with interest.
Because of my set up, (rudimentary construction table saw and very basic bench, {uneven top} and vice facility) I wanted to find an accurate yet cheap way for mortising with a router.
I considered a horizontal router table ( to pricey) and several other jigs which my set up unfortunately did not encourage.
However, after trawling the web I think I have found my answer. I will include a photo when I have finished it but here it is so far
.
Just need to finish off the stop blocks
It fits in your vice and will allow mortises up to 6"long and (6"deep if you have a cutter that long.)
The link for the jig isHERE
Much other useful stuff also.
You are looking for "Tade Frig's Mortising Jig" under 'Routers.'
Hope this helps others
cheers
billzee
Because of my set up, (rudimentary construction table saw and very basic bench, {uneven top} and vice facility) I wanted to find an accurate yet cheap way for mortising with a router.
I considered a horizontal router table ( to pricey) and several other jigs which my set up unfortunately did not encourage.
However, after trawling the web I think I have found my answer. I will include a photo when I have finished it but here it is so far
Just need to finish off the stop blocks
It fits in your vice and will allow mortises up to 6"long and (6"deep if you have a cutter that long.)
The link for the jig isHERE
Much other useful stuff also.
You are looking for "Tade Frig's Mortising Jig" under 'Routers.'
Hope this helps others
cheers
billzee