A question of no consequence, really, just my idle curiosity.
Why is the pitch of the holes on the MFT and clones 96mm? Why not 100mm?
Thanks
Geoff
Why is the pitch of the holes on the MFT and clones 96mm? Why not 100mm?
Thanks
Geoff
Yes, there’s a link on that video to this old thread on Festool Owners Group that explains the 32mm system well:-See Peter Millard's 10 Minute Workshop YT film yesterday (30 Oct 20) - he makes reference to it when looking at a spangly MFT top
Thanks Peter - the thread on the FOG link you gave was very enlightening.Yes, there’s a link on that video to this old thread on Festool Owners Group that explains the 32mm system well:-
96 mm MFT hole spacing
The 96mm spacing is an extension of that, AFAIK.
Enter your email address to join: