Hi guys,
I’ve recently bought a planer thicknesser with a tersa block. It turns out the previous owner wasn’t to precious with it and while cleaning the ‘resin! From the block it dawned on me the deposits are actually glue, obviously couldn’t wait for it to dry before machining!
So here lies my issue, I would like to removed the centrifugal wedges and bolt on components to give a good clean and check everything seats correctly free from unwanted deposits, however my manual clearly says do not remove the Allen bolts holding the section the blades seats on! Is this critical information or can those parts be removed, cleaned, inspected and replaced without causing major problems?
I may be being a bit over cautious but would rather be safe!
thanks
I’ve recently bought a planer thicknesser with a tersa block. It turns out the previous owner wasn’t to precious with it and while cleaning the ‘resin! From the block it dawned on me the deposits are actually glue, obviously couldn’t wait for it to dry before machining!
So here lies my issue, I would like to removed the centrifugal wedges and bolt on components to give a good clean and check everything seats correctly free from unwanted deposits, however my manual clearly says do not remove the Allen bolts holding the section the blades seats on! Is this critical information or can those parts be removed, cleaned, inspected and replaced without causing major problems?
I may be being a bit over cautious but would rather be safe!
thanks