Makita 3612 C

[Fat ferret]

Had this router years and mostly use it for rebating but I wanted to make it a table as I have lots of grooves to cut. They are 1" wide by 1/2" deep in 1 1/4 x 1 3/4 red pine.

Can't work out how to make it run hands free. I read online manual but no joy. Seems like if you hold the lever on the trigger should stay on but mine doesn't.

 

[marcros]

cable tie on the trigger, but make sure you have an nvr switch on your table.

 

[Racers]

+1

Pete

 

[Mar_mite]

I use insulation tape. Just take it off after use otherwise it could get all gummy.

 

[user 19915]

yes as above i have the same router cable or tape

 

[Fat ferret]

OK cheers. Didn't think it could be that simple . I will see about getting a mounting plate made up,

Do you recon a good solid table with my router will do the job I mentioned?

 

[Racers]

I used to use a old MFC kitchen shelf with my 3621c screwed on, and a length of 2x2 for a fence. it worked fine.

Pete

 

[marcros]

the router will do the job fine, on as simple or complex table as you wish to make. I would do it in several passes though rather than trying to do it in one.