machine tool stand for router table base

[Selwyn]

http://www.amazon.co.uk/Silverline-1299 ... B001JJVMDA

Would this be good enough for a router table base?

or would anyone care to rate this:

http://www.ebay.co.uk/itm/PRO-ROUTER-TA ... Sw42JWC8Ux

 

[marcros]

the base will probably do ok, but it is not great. it is too low and the hole is plenty small enough. Personally, I would spend your £27 on wood, and a piece of worktop offset and make one.

The eBay one looks like the Rutlands one. I have one of these and it is solid- the fence is well made. They are normally about £100 without the featherboards.

 

[Hemsby]

the base will probably do ok, but it is not great. it is too low and the hole is plenty small enough. Personally, I would spend your £27 on wood, and a piece of worktop offset and make one.

The eBay one looks like the Rutlands one. I have one of these and it is solid- the fence is well made. They are normally about £100 without the featherboards.

+1 For homemade

This is a link for my recent build, althought the post is for the full Monty you may get an idea :idea: on the table itself. I bought an offcut for the top for £10 the rest of the timber about £20 worth.

router-table-build-t90615.html

You will get the table you want and the satisfaction of the build (hammer) .

Regards