I had the same problem, and having bought it from a friend all in parts without a manual, FIRSTLY HAVE YOU GOOGLED your machine to see what is available, that's where I acquired some drawings, as for grease points you will need a grease gun with a selection of attachments, a pointed one is a must, as some grease points are not easy to get at, use good quality grease, not oil as some have done, never use oil on a ball race, only bronze bearings are normally oiled, I had to replace the electric motor and switch gear, and had to have a pulley made for the new motor spindle, all works very well, I have not bothered about the spindle molder, as I am never likely to use it.
Good luck, but most of all take care when you get it going, with a big blade things can fly!
Ian
PS I just Googled the Lurem, there are lots of info with pictures and drawings available, that's if you can read French, however you can translate any of the emails relating to questions raised by users in France....