Kity 619 with spindle moulder - blade alignment

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

andremlanca

Member
Joined
8 Jun 2020
Messages
5
Reaction score
0
Location
LISBOA
Hello guys! I'm new to the forum. I have a kitty 619 with a router table. The blade is off by 1mm and i've tried everything. I loosen all the bolts and tried tapping the table, but the blade moves along with it, since it is bolted to the cast alloy top. I tried adjusting the hinges where the blade rest upon, but it will eventually come out of alignement again after a few cuts. I'd like to know if anyone has any tip that could serve of any help. this is driving me insane!!! Thank you all in advance!
 
Back
Top