heimlaga
Established Member
I may or may not get the opportunity to buy a Dornburg 610mm thicknesser next summer.
However the cutterhead is of the dreaded clamshell type and in rather bad condition on top of that. The rest of the machine looks to be in good condition and it may end up very very cheap.
So.....any ideas for where or how I could get a suitable cutterhead at a not too exorbitant cost?
However the cutterhead is of the dreaded clamshell type and in rather bad condition on top of that. The rest of the machine looks to be in good condition and it may end up very very cheap.
So.....any ideas for where or how I could get a suitable cutterhead at a not too exorbitant cost?