phantombantam
Established Member
Hi everyone,
im looking for some advice with insulating my ew garden building. It's single dense concrete block 8 m x 4m with an internal partition wall to separate the shed and garden room area. This leaves approx 6 x 4 m room to insulate.
Here is my basic plan. 80mm tf70 thermafloor on top of DPM on concrete slab floor then 22mm caberfloor tongue and groove floating floor. 50mm pir on walls with 50mm air gap and then 100mm pir between rafters leaving a 50mm gap to the roof boards.
Does this sound ok? just trying to plan in my mind before ordering materials.
slight problem with how to work around internal double block pillars x 2 which are one either side of french doors and two on the opposite long wall.
outside was treated with storm dry before winterand has since been rendered with parex which will also be treated with paraguard so it's watertight
im looking for some advice with insulating my ew garden building. It's single dense concrete block 8 m x 4m with an internal partition wall to separate the shed and garden room area. This leaves approx 6 x 4 m room to insulate.
Here is my basic plan. 80mm tf70 thermafloor on top of DPM on concrete slab floor then 22mm caberfloor tongue and groove floating floor. 50mm pir on walls with 50mm air gap and then 100mm pir between rafters leaving a 50mm gap to the roof boards.
Does this sound ok? just trying to plan in my mind before ordering materials.
slight problem with how to work around internal double block pillars x 2 which are one either side of french doors and two on the opposite long wall.
outside was treated with storm dry before winterand has since been rendered with parex which will also be treated with paraguard so it's watertight
Last edited: