Woodythepecker
Established Member
- Joined
- 30 Jul 2004
- Messages
- 686
- Reaction score
- 0
If there is any diy job i hate its decorating. But as SWMBO has spoken i have no choice but to get the tools out and get on with it.
I have to gloss the internal doors, but in the past i have found that i cannot get all the brush strokes out (to my satisfaction anyway), and i was wondering if i could use a foam brush, and if so would it give a better finish then the normal hair type brush?
The reasoning behind this is that one brush has hundreds of hairs to leave lines, where as the other one can only leave two lines, one on either side of the foam edge.
On the other hand the problem could be down to my technic.
Any advice would be welcome.
Regards
Woody
I have to gloss the internal doors, but in the past i have found that i cannot get all the brush strokes out (to my satisfaction anyway), and i was wondering if i could use a foam brush, and if so would it give a better finish then the normal hair type brush?
The reasoning behind this is that one brush has hundreds of hairs to leave lines, where as the other one can only leave two lines, one on either side of the foam edge.
On the other hand the problem could be down to my technic.
Any advice would be welcome.
Regards
Woody