Heath Robinson
Established Member
I've got a DCS576 track saw, and it's been fantastic for most of the time I've had it. However, it's started cutting curves, to the point that the blade contacts the rail if you push it too far. I assumed it was the fault of the blade so I've changed that for a new one, but 3rd cut with the new blade - same deal. 18mm ply, whole tooth exposed below the sheet but only just, well supported, saw adjusted to grip rail without play, all things as they should be.
I've done a couple of cuts against a big speed square, and it appears to veer off to one side with that too.
Anyone experienced anything like this, or better yet found a solution? I'm a trek away from my repair centre, and I don't want to be without the thing at the moment!
I've done a couple of cuts against a big speed square, and it appears to veer off to one side with that too.
Anyone experienced anything like this, or better yet found a solution? I'm a trek away from my repair centre, and I don't want to be without the thing at the moment!