Gordon Moore
Member
Hi All , newbie and DIY sorry
this is my third table saw after a couple of the cheaper ones that frustrated me trying to get the level of accuracy I would like.
I have been setting it up and adjusted the fence to within 0.02mm which I’m guessing is acceptable. I would also like to tweak the blade alignment as it’s towing out about 0.3mm . The issue I have is the two hex screws are incredibly tight and with a standard size key was unable to break them free. From those that know is it just a case of a longer lever or put some gloves on and give some more effort
many thanks
Gordon
this is my third table saw after a couple of the cheaper ones that frustrated me trying to get the level of accuracy I would like.
I have been setting it up and adjusted the fence to within 0.02mm which I’m guessing is acceptable. I would also like to tweak the blade alignment as it’s towing out about 0.3mm . The issue I have is the two hex screws are incredibly tight and with a standard size key was unable to break them free. From those that know is it just a case of a longer lever or put some gloves on and give some more effort
many thanks
Gordon