Cutlist Widths

[matt]

Unless I'm going nuts, Cutlist is a bit limited when it comes to dimensioned timber... It seems to assume that timber widths go up in standard, fixed, width increments. Not at my timber yard...

Am I missing something?

EDIT: And it does not seem possible to set the planed size per nominal size - it assumes some kinda US based relationship.

All this just means that I end up with a shopping list that does not match what is available at my timber yard...

Back to pen and paper...

(still full marks for laying out sheet goods though).

 

[Marky]

just go into the settings menu...

nominal sizes...

and add your own sizes.

I.e. a 25.4mm board that is still 25.4mm on the actual thickness.

 

[matt]

just go into the settings menu...

nominal sizes...

and add your own sizes.

I.e. a 25.4mm board that is still 25.4mm on the actual thickness.

Done that for thickness but width... It seems only to allow a fixed incremental value (bottom right-hand field in the same window).