ColG
Established Member
I finally opted to go for the EZ saw guide system from Eurekazone having watched it's development over that last couple of years.
I had a project that involved cutting a load of melamine faced MDF and I already had 3 CSs so wasn't about to splash out on a Festool system.
Anyway, I slightly cocked up the setup when fixing the base to my saw - discovered when I posted a question relating to poor cuts on another forum.
Not only did Dino (the inventor) respond personally, he asked me to contact him. The upshot was that within 5 days, I had new parts shipped airmail direct from the states at NO cost to me.
Now forgive me if I talk out of turn but could anyone convince that Festool, Maffell or any of the other guide rail systems provide the same level of satisfaction?
Does this "cheapo" system do the job? You bet it does.
I had a project that involved cutting a load of melamine faced MDF and I already had 3 CSs so wasn't about to splash out on a Festool system.
Anyway, I slightly cocked up the setup when fixing the base to my saw - discovered when I posted a question relating to poor cuts on another forum.
Not only did Dino (the inventor) respond personally, he asked me to contact him. The upshot was that within 5 days, I had new parts shipped airmail direct from the states at NO cost to me.
Now forgive me if I talk out of turn but could anyone convince that Festool, Maffell or any of the other guide rail systems provide the same level of satisfaction?
Does this "cheapo" system do the job? You bet it does.