Chronosoft
Established Member
Hi,
bought a second hand TS2000 a few weeks ago - I thoroughly cleaned it and gave the tables a good coat of wax - however - my rip fence isn't square when it is tightened up and the sliding table ever so slightly runs out on its length.
I have set the table up with the original manual and everything seems to run fine - followed this quite closely so I am confident everything is set up as per the manual.
Is there something I am missing with the setup or is it just a case of shimming out the various parts after I have been round it with a feeler gauge.
Also - where can i buy shims from if needed ?
Cheers
David
bought a second hand TS2000 a few weeks ago - I thoroughly cleaned it and gave the tables a good coat of wax - however - my rip fence isn't square when it is tightened up and the sliding table ever so slightly runs out on its length.
I have set the table up with the original manual and everything seems to run fine - followed this quite closely so I am confident everything is set up as per the manual.
Is there something I am missing with the setup or is it just a case of shimming out the various parts after I have been round it with a feeler gauge.
Also - where can i buy shims from if needed ?
Cheers
David