ok, I spent the entire yesterday trying to get my thicknesser planer to plane a straight edge on some pine (which should`nt be a difficult task)
heres the pipper
https://www.ukworkshop.co.uk/gallery/det ... age_id=247
and heres the results its producing:
https://www.ukworkshop.co.uk/gallery/det ... age_id=246
both boards were run over the planer, and just out of shot the boards ARE touching.
The reults are extreamly bad!, I have no idea where I`m going wrong, does anyone have any ideas???
has anyone else produced rubbish like this whilst learning and thus know where I`m going wrong???
heres the pipper
https://www.ukworkshop.co.uk/gallery/det ... age_id=247
and heres the results its producing:
https://www.ukworkshop.co.uk/gallery/det ... age_id=246
both boards were run over the planer, and just out of shot the boards ARE touching.
The reults are extreamly bad!, I have no idea where I`m going wrong, does anyone have any ideas???
has anyone else produced rubbish like this whilst learning and thus know where I`m going wrong???