Hello,
I received about a month ago an Axminster AC2606 bandsaw. Im struggling to get the blade centered. When I put the blade in, I center it on the top wheel. Then, when tensioning it, the blade moves forward (which is fine), so I correct it using the tracking knob.
However, when I feel enough tension has been applied, the blade is at the very front of the wheel, and the tracking knob is fully turned (no more room to screw it further).
Has any of you got this issue ? is there a way to correct that ? (like using shims, or put a longer screw on the tracking knob).
Or am I just doing it wrong ? :roll:
I received about a month ago an Axminster AC2606 bandsaw. Im struggling to get the blade centered. When I put the blade in, I center it on the top wheel. Then, when tensioning it, the blade moves forward (which is fine), so I correct it using the tracking knob.
However, when I feel enough tension has been applied, the blade is at the very front of the wheel, and the tracking knob is fully turned (no more room to screw it further).
Has any of you got this issue ? is there a way to correct that ? (like using shims, or put a longer screw on the tracking knob).
Or am I just doing it wrong ? :roll: