bp122
Expert at Jibber-Jabber
Hello all,
1. In a Bandsaw-Planer combo setup without a thicknesser, how does one go about achieving straightness and flatness on faces #3 and #4, where faces #1 and #2 are done on the planer?
2. Bandsaw vs Table saw – dust management (I know the volume is directly proportional to the kerf width, but the question is which one is messier after a cut – assuming reasonable quality blade and feed)
3.Table saw gives a reasonable finish upon cross cutting small bits (let us say 20mm x 20mm x 20mm block) – How does one get the same finish with just bandsaw-planer combo (without a mitre saw)?
4. What is the relationship between the size of bandsaw (10", 12", 14" etc) to the max height of cut (if there is such a thing)?. Reason I ask is because not everyone in the used market lists the height (I think I mean depth) of cut.
I am purely asking from a point of not knowing, and don’t mean to ruffle feathers on insult anyone.
Cheers.
1. In a Bandsaw-Planer combo setup without a thicknesser, how does one go about achieving straightness and flatness on faces #3 and #4, where faces #1 and #2 are done on the planer?
2. Bandsaw vs Table saw – dust management (I know the volume is directly proportional to the kerf width, but the question is which one is messier after a cut – assuming reasonable quality blade and feed)
3.Table saw gives a reasonable finish upon cross cutting small bits (let us say 20mm x 20mm x 20mm block) – How does one get the same finish with just bandsaw-planer combo (without a mitre saw)?
4. What is the relationship between the size of bandsaw (10", 12", 14" etc) to the max height of cut (if there is such a thing)?. Reason I ask is because not everyone in the used market lists the height (I think I mean depth) of cut.
I am purely asking from a point of not knowing, and don’t mean to ruffle feathers on insult anyone.
Cheers.