I'm wonder if how best to construct panels for the sides and rear of a tv cabinet. I was considering biscuit joining 3 x 150mm wide strips of wood together to form a panel, and then dropping this panel into grooves routed into the aprons.
The problem with this, as far as I can see, is that this wouldn't allow for any movement/expansion of the wood. If didnt use any glue, or even cut tenons onto the end of the panel, then I suppose this would work, assuming I cut the grooves a lot deeper than the panel to give clearance. But this seems like it would result in quite a loose fit. How would people on here recommend doing it? Cheers
The problem with this, as far as I can see, is that this wouldn't allow for any movement/expansion of the wood. If didnt use any glue, or even cut tenons onto the end of the panel, then I suppose this would work, assuming I cut the grooves a lot deeper than the panel to give clearance. But this seems like it would result in quite a loose fit. How would people on here recommend doing it? Cheers