j1mbr0wn
Established Member
When i am hollowing i seem to be getting a bit of vibration, because the head can swing round i moved it round to see if there was anything obstruction and notices that it sits on a sort of dome and about 2mm from the top of the actual bed, is that normal.
Checking to see if the 2 centers meet when its like that and they do just fine, so gave it a twist round so that its seated ok and a good old tighten up but still some vibes coming.
Does anyone have good knowledge of this lathe, I have 2 chucks a dakota x700 and a small barracuda one, both vibrate similarly.
Thanks
Checking to see if the 2 centers meet when its like that and they do just fine, so gave it a twist round so that its seated ok and a good old tighten up but still some vibes coming.
Does anyone have good knowledge of this lathe, I have 2 chucks a dakota x700 and a small barracuda one, both vibrate similarly.
Thanks