Attaching Domino to tracksaw rail

[marcros]

This flashed up on my Facebook news feed and it looks like a useful idea.

Festool Domino Rail Connector Connect your DF 500 to Guide | Etsy

probably very expensive by the time it gets over here.

how does everybody else achieve this, clamp a batten to the piece to be domino'd?

 

[Rorschach]

From what I can see @petermillard just rests the Domino against the back edge?

Doesn't look like it would be too hard to make your own version of that from some scraps and an angle bracket but I can't see it being as useful as say the router attachments (made my own of that too, also not hard).

 

[Nelsun]

That's fancy looking but I see one inherent problem which is it has to slide along the rail which rules out setting any stops in the accessory slot to register against. So you're left relying on pencil marks and such.

I like to use (all from Benchdogs.co.uk) a piece of 2040 extrusion locked in place with fence dogs and flag stops to butt up against. The flag stops have the added bonus of being able to flip to either side of the extrusion allowing you to mirror you registration points. This works for putting dominos across a board slid under the extrusion too - so long as it's not super thick as the fence dogs only go so high.